Effect Dirty Down modelling paint

• Realistic water-soluble modelling paints.
• Simulate the effect of rust, mildew, dirt and much more.
• They are used straight from the bottle and are applied by brush or spray.
• The effects of the paint are lost if washed off with water or wetted.
• Directions for use:
• - Before use shake well and stir inside with an old brush until all lumps are gone.
• - For best results, the container and surface to be painted should be at room temperature or slightly warmer. The colour may darken if the surface is too hot or too cold.
• - Tip : hold the container in your pocket against your skin for an hour before use and shake it regularly with the ball bearing rattling. Repeatedly stir and shake the container until all lumps disappear.
• - Always clean the brush with water or denatured alcohol immediately after use (not with mineral spirits). Do not allow the paint to harden completely on the brush.
• - Do not add water to the paint pot, it is best to pour some paint into a separate pot and then add small amounts of water. Or, to lighten the colour, apply the paint to a surface with a damp or wet brush. Or, after painting, dab the paint wet or dry with a damp brush.
• - Make sure surfaces are clean, dry and free of grease.
• - Do not expose the paint to rain or splashing water.
• - To fill dents and grooves in surfaces, first cover the surface with paint and then wipe the paint off the raised areas with a damp cloth (at an angle to the grooves), leaving some of the paint trapped. The wetter the cloth, the more paint will be removed.
• - To darken the tone, apply more coats. Allow each coat to dry completely before applying another.
• Available in different colours and sizes.

Brand: Dirty Down.